Infineon Technologies KIT_T2G-B-H_LITE TRAVEO™ T2G Evaluation Kit
Infineon Technologies KIT_T2G-B-H_LITE TRAVEO™ T2G Evaluation Kit enables the evaluation and development of customer applications using the TRAVEO T2G Body High MCU. The MCU is a true programmable embedded system-on-chip, integrating up to two 350MHz Arm® Cortex®-M7 as the primary application processors, a 100MHz Arm Cortex-M0+ that supports low-power operations, up to 8MB flash, 1MB SRAM, a Secure Digital Host Controller (SDHC) supporting SD/SDIO/eMMC interfaces, and programmable analog/digital peripherals that allow faster time-to-market.The evaluation board carries a TRAVEO T2G-B-H microcontroller, a MikroBUS, two Sheild2Go connectors, and headers compatible with Arduino for interfacing Arduino shields. In addition, the board features an onboard programmer/debugger(KitProg3), a 512-Mbit QSPI NOR flash, a CAN FD transceiver, an Ethernet PHY transceiver with RJ45 connector interface, a micro-B connector for USB device interface, three user LEDs, one potentiometer, and two push buttons. The board supports operating voltages from 3.3V to 5.0V.
ModusToolbox™ software is a set of tools that can be used to develop/debug TRAVEO™ T2G-B-H MCU projects and enable integration into user-existing development methodology.
Features
- Power
- KitProg3 USB Micro-B interface (Bus Power)
- DC power jack (recommended 12V, 1A minimum)
- Ethernet physical layer (PHY) transceiver
- CAN FD transceiver
- 2x user buttons, 5x user LEDs
- Reset button
- Potentiometer to simulate analog sensor output
- RoHS compliant
- Connectors
- Arduino compatible connectors
- Shield2Go connector
- mikroBUS™ connector
- Expansion header
- CAN connector
- RJ45 connector
- MIPI10/20 DEBUG connector
Applications
- Automotive electronics applications
- Body control modules (BCM)
- Heating, ventilation, and air conditioning (HVAC)
- Motor control
- Lighting
- Automotive gateways
Block Diagram
Board Layout
Published: 2023-11-10
| Updated: 2025-10-08
