All Results (1.865)

Multiple Function Sensor Development Tools The MyoWare 2.0 Muscle Sensor is designed to be wearable allowing you to attach biomedical sensor pads directly to the board itself. However there still may be cases where you want to mount the sensor pads away from the board; this is where the M

Multiple Function Sensor Development Tools The MyoWare 2.0 Arduino Shield is designed to easily connect up to six MyoWare 2.0 Muscle Sensors and Link Shields using 3.5mm TRS-to-TRS audio cables. The board comes pre-populated with male headers so all you would need to do is stack it on your

Interface Development Tools The SparkFun USB-C Host Shield contains all of the digital logic and analog circuitry necessary to implement a USB peripheral/host controller with your Arduino. This means you could use your Arduino to interface with and control any USB 2.0 compatibl

Educational Kits The great thing about open source is that while SparkFun has designed our own MicroMod carrier boards that does not stop you from creating your very own MicroMod carrier board. The MicroMod DIY Carrier Kit includes five M.2 connectors (4.2mm height)

Display Development Tools Micro OLED Breakout OLED Breakout

Display Development Tools Add a vibrant 16x2 Black on RGB Liquid Crystal Display to your custom electronics without the traditional wiring headache. The SparkFun SerLCD streamlines the entire process by mounting an AVR ATmega328P microcontroller directly to the back of the s

Test Plugs & Test Jacks This is a red insulated binding post. These binding posts do accept banana plugs and are a great way to connect single-wire leads. The colored cap screws up and down and is designed to clamp on the connecting wire.These binding posts are sold indiv

Power Management IC Development Tools The LiPower board is based on the incredibly versatile TPS61200 boost converter. The board is configured to be used with a LiPo battery has solder jumper selectable 5V and 3.3V output and an under voltage protection of 2.6V. However the board can

SparkFun Accessories This is a very handy magnetic mount for survey grade GNSS/GPS antennas. Sturdy compact and surprisingly strong this is a quick way of mounting your antenna to metal roofs parapets and other ferrous materials. The rod is threaded 5/8" 11-TPI (thr

Headers & Wire Housings This is a 2x5 pin 1.27mm header.

Solenoids & Actuators Solenoids are a great way to induce linear motion for pushing pulling or controlling switches and levers. According to the datasheet this solenoid is rated for 36V but they work like a charm at 12V. We've been controlling them with the Arduino Power

Power Management IC Development Tools EasyDriver - Stepper Motor Driver